 |
The Boot |
|
 |
| |
|
The boot installed on the MGW shifter looks like
this |
| |
|
|
 |
| The factory inner boot on your car needs to be modifed by
simply cutting out the center first rib of the accordion shape.
It should look like this (above). |
|
| |
|
|
 |
| Now you can simply push the FACTORY inner boot down around
the BASE of the MGW shifter and then install the MGW boot
on top of the center shaft and around the shifter base. It
looks like this when installed (above). |
|
| |
|
|
The benefts are many with this new boot....
- It is not as stiff as the factory second inner boot that some
guys are putting on the MGW shifter. The one that is connected
to your factory shifter.
- Allows the picture frame inner boot pictured above to seal
the base of the MGW shifter from all dust and moisture and also
reduces road noise by a good amount.
- The MGW boot SEALS the top of the shifter from any dirt or
debris and also still gives a nice free feel to the shifter.
It also muffles road noise and tranny whine coming up from the
shifter.
|
| Return to MGW shifter
page |
